Exoticspeed
Customer Support+1-778-999-8588 / sales@exoticspeed.com

Garrett Dual Ball Bearing Twin-scroll GT3071R Bolt-on Turbo Kit, EVO X - Internally wastegated

Description

Model Years: 2008 +

Engine: 2.0L 4B11 Turbocharged Inline 4

The Garrett® Evo X Turbo Upgrade allows you to push your AWD, rally-bred monster up to an estimated 475 HP with the Garrett® GT3071R (PN 788550-1) or a tire-smoking estimated 525 HP with the Garrett® GT3076R (PN 788550-2). Each turbo has been meticulously designed to be a bolt-on upgrade with no fabrication, cutting or welding required.

The Garrett® Evo X Turbo Upgrade features a specially designed twin-scroll turbine housing that mates up directly to the Evo X's stock exhaust manifold as well as the stock exhaust down pipe to allow for aftermarket exhausts to be used without worrying about fitment.

The turbine housing allows for the retention of the stock exhaust heat shield for better temperature control as well as a stealth look.

The ported shroud compressor housing reduces the occurrence of surge during operation and mates directly to the intake piping as well as the stock outlet position.

The Garrett® patented dual ball bearing center housing is standard on both turbocharger options for unmatched power handling and unbeatable response.

The Garrett® Evo X Turbo Upgrade is a powerful, yet highly streetable enhancement to an already potent car.
      GT3071R
PN 788550-1
Horsepower (estimated)     475
Compressor Wheel Inducer     53.1mm
Compressor Wheel Exducer     71.0mm
Compressor Wheel Trim     56
Compressor Housing A/R     0.60
Turbine Wheel Diameter     60.0mm
Turbine Housing A/R     0.73

Kit Contains:
  • Garrett® GT3071R (PN 788550-1) dual ball bearing application specific turbocharger
  • Inlet elbow
  • Oil drain line
  • Water lines
  • Gaskets and necessary hardware
  • Installation Instructions
PLEASE NOTE: Turbos with BIG wheel combinations such as these require good airflow in and out of them in order to do their job efficiently. Whenever possible, run the largest diameter inlet piping (3" preferred) to allow adequate airflow into the turbo and 3" diameter piping out of the turbine exhaust to facilitate maximum flow. Allowing the turbo to inhale and exhale freely through large pipingwork will allow you to attain the desired HP easier with often much less boost pressure during your tuning process. Failure to free up the turbo's flow potential can force the turbo to "top out" in power prematurely and undoubtably place your entire engine/turbo against the perpetual "wall" and always short of reaching maximum power.

Warranty

  • Note: Products sold through this website that do not bear the Exoticspeed Brand name are serviced and supported exclusively by their manufacturers in accordance with terms and conditions packaged with the products. Exoticspeed Limited Warranty does not apply to products that are not Exoticspeed-branded, even if packaged or sold with Exoticspeed products. Please contact the manufacturer directly for technical support and customer service.
  • Warranty: One year
$2,039.99 USD
Available Options

Related Products